※Note：Be cautious when create or deleting a RAID set. Select the disks that you want to create and set to ，as below picture mark red 3ġ2. Set RAID capacity and click to create RAID Set RAID name ,for example :SATAHDDRAID0，as below picture mark red 1Ĭhoose RAID Level, for example :RAID0(Stripe)，as below picture mark red 2 Press F7 key and enter as below pictureĩ. Press “delete”key after the system reboot and enter BIOS Ĩ. Press F10 key and click OK then the system will auto rebootħ. If you want to create M.2 Storage RAID to ，as below picture mark red 2Īs below：click and set to Ĭlick and set to ĥ. If you only create SATA RAID, then just follow next setup item and set to ，as below picture mark red 1

(If press “delete” key enter directly and then no need to press F7 key)ģ. Power on the system and press“delete”key to enter BIOS ，check the connect drive in Storage InformationĢ. Press F7 key and enter as below picture You will lose all data on the hard disk drives when you delete a RAID set, so please back up your data before create or deleting a RAID set.įollow below setup to create RAID in BIOS setup：ġ.

※ Note ：Be cautious when create or deleting a RAID set. RAID 10 is data striping and data mirroring combined without parity (redundancy data) having to be calculated and written. RAID 5 :strips both data and parity information across three or more hard disk drives. RAID 1 : (Data mirroring) copies and maintains an identical image of data from one drive to a second drive. RAID 0 : (Data striping) optimizes two identical hard disk drives to read and write data in parallel, interleaved stacks. RAID：Redundant Arrays of Independent Disks

Hdd mark